Magnetic separation process

PTMS MAGNETIC SEPARATOR

what is magnetic separation in science?

The pipeline type iron remover can be used only by connecting the inlet and outlet flanges in series with the material conveying pipe, and the device is very convenient. However, the following points should be noted when adjusting the device of the pipeline type iron remover:

1. The inclination angle of the pipeline type iron remover device (the angle between the center line of the discharge port and the horizontal plane) is preferably 55o-60o; the directions on both sides are not skewed (that is, the motor axis is kept horizontal). The discharge port should not be tightly connected with the tapping pipe. It should be connected with a rectangular iron bucket or a trough-shaped iron trough. The distance between the taphole and the iron bucket is 60mm. The Qingdao shot blasting machine can remove the iron mouth if necessary. Perhaps the blocker (wire, material block, etc.) presented.

2. The electric control system of the pipeline type iron remover can be directly connected to the power supply, and the equipment can work alone; it can also be controlled by the powder conveying system, and the opening and closing of the system determines whether the equipment is operated or not.

3. It is necessary to insert gasket or asbestos rope between the joints of the inlet and outlet flanges. The hook-type shot blasting machine ensures the sealing function of the joint to prevent dust from polluting the environment.

4. The direction that must be observed after receiving the first power supply device is correct. The following two methods can be selected: A. Investigate the steering gear reduction motor, and rotate its direction according to the direction of the chain watt protocol. B. Open the side of the investigation port and place a ferromagnetic material (nut, etc.) with a particle size of less than 22 mm on the surface of the adsorption baffle. The data of the American Red Mape is accurate to the downward movement. If the direction of movement is not accurate, stop immediately, change the direction of rotation of the motor, and try again.

5, before use should be based on the amount of ferromagnetic debris in the powder, properly adjust the start or stop of the motor, adjust the button of the relay in the electric control box, these two time to change, its value can be directly on the button Was investigated. Refer to the selection time: 10 seconds for exercise time and 3 to 10 minutes for intermittent time. Users can use, investigate, view, and determine the best time for each iron discharge not exceeding 3kg. If the powder contains more iron or the temperature of the powder is too high, the working mode of the reducer can be used continuously.

The company has a complete comparison of processing, inspection equipment, advanced skills, sophisticated technology, and sophisticated equipment to ensure that excellent and reliable products are sold nationwide. The goods that the user meets can be planned according to the special situation of the user site.